Category: Driver Module
Showing 1–16 of 216 results
-
10 Pcs Geekcreit L298N Dual H Bridge Stepper Motor Driver Board
$35.09Driver ModuleAdd to cartDescription Double H bridge drive Chip:L298N (ST NEW) Logical voltage:5V Drive voltage:5V-35V Logical current:0mA-36mA Drive current:2A (MAX single bridge) Storage temperature:-20 to +135 Max power:25W Weight:30g Size:43 x 43 x 27mm Note This module has a built-in 5v power supply, when the driving voltage is 7v-35v, this supply is suitable for power supply, DO NOT …
10 Pcs Geekcreit L298N Dual H Bridge Stepper Motor Driver BoardRead More
-
100W Dimmer Module Dimmer Circuit Board Switch Desk Lamp Dimmer Board
$8.09Driver ModuleAdd to cartFeaturePCB board size:2CM*3.3CMRated power:P=UI; 100W=220V*0.45AModel:100W dimming module;Rated power:100W;Suitable for dimming and speed adjustment of AC motors and lamps below 100W (energy-saving lamps are not supported);Package includes1 x 100W dimming module
-
10pcs 15-24W LED Driver Input AC90-265V to DC45-82V Built-in Drive Power Supply Adjustable Lighting for DIY LED Lamps
$36.44Driver ModuleAdd to cartSpecificationsInput voltage:AC90-265VOutput voltage:DC45-82VOutput current:280-300mA(adjustable)Product size:50*20*15mmWorking temperature:Ta:50 TC:75Efficiency:≥87%Power factor:0.6Product application:spotlight PAR light / bulb light / candle light / etc.Package Included10 x 15-24W LED Driver Input AC90-265V to DC45-82V
-
10pcs 3W 5-35V LED Driver 700mA PWM Dimming DC to DC Step-down Module Constant Current Dimmer Controller
$25.64Driver ModuleAdd to cartSpecificationsInput:DC 5-35VOutput:700mA ± 20mADrive 1-10 pcs 3W LEDSupports PWM dimmingHigh level turn off the outputLow level Open the outputLED buck mode to ensure the total total voltage difference is lower than the input supply voltage (2-3V) .Ultra-small size design (length 3.6cm * Width 2cm)Constant output current, low ripple.LED used to ensure the safety, stability, improving …
-
10pcs 4CH 4 Channel HG7881 Chip H-bridge DC 2.5-12V Stepper Motor Driver Module Controller PCB Board 4 Way 2 Phase
$40.49Driver ModuleAdd to cartFeaturesMotor drive module comes with its own four HG7881 chip.Can drive 4 DC motors, or two 4-wire 2-phase stepping motor.SpecificationsModule supply voltage:2.5-12VSuitable for the motor range:motor operating voltage 2.5V-12V0.8A maximum operating currentSize:49mm x 36mmColor:BlueInterface Description[10P black curved pin instructions]1 A1 external MCU IO port2 A2 external MCU IO port3 B1 external MCU IO port4 B2 …
-
10pcs 4W 5W 6W 4-6W LED Driver Input AC 85-265V to DC 12V-24V Built-in Drive Power Supply Lighting for DIY LED Lamps
$17.54Driver ModuleAdd to cartSpecificationsInput voltage:AC 85-265VOutput voltage:DC12-24VOutput current:280-300mA(adjustable)Product size:20*18*12mmWorking temperature:Ta:50 TC:75Efficiency:≥87%Power factor:0.6Product application:spotlight PAR light / bulb light / candle light / etc.Package Included10 x 4W 5W 6W 4-6W LED Driver Input AC 85-265V to DC 12V-24V
-
10pcs 5W LED Driver Input AC110/220V to DC 15-18V Built-in Drive Power Supply Adjustable Lighting for DIY LED Lamps
$18.89Driver ModuleAdd to cartSpecificationsInput voltage:AC110V-220VOutput voltage:DC 21V-45VOutput current:280-300mA(adjustable)Product size:27*17*9mmWorking temperature:Ta:50 TC:75Efficiency:≥87%Power factor:0.9Product application:spotlight PAR light / bulb light / candle light / etc.Package Included10 x 5W LED Driver Input AC110/220V to DC 15-18V
-
10pcs 6W 7W LED Non Isolated Modulation Light External Driver Power Supply AC110/220V Constant Current Thyristor Dimming Module
$25.64Driver ModuleAdd to cartSpecificationsInput voltage:AC90-265VOutput voltage:DC18-24VOutput current:280-300mA(adjustable)Product size:68*33*22mmWorking temperature:Ta:50 TC:75Efficiency:≥90%Power factor:0.9Product application:spotlight PAR light / bulb light / candle light / etc.Package Included10 x 6W 7W LED Non Isolated Modulation Light External Driver
-
10pcs 7-15x3W LED Driver Input AC110V-220V to DC 21V-45V Built-in Drive Power Supply Adjustable Lighting for DIY LED Lamps
$56.55Driver ModuleAdd to cartSpecificationsInput voltage:AC110V-220VOutput voltage:DC 21V-45VOutput current:450-580mA(adjustable)Product size:53*36*16mmWorking temperature:Ta:50 TC:75Efficiency:≥87%Power factor:0.65Product application:spotlight PAR light / bulb light / candle light / etc.Package Included10 x 7-15x3W LED Driver Input AC110V-220V to DC 21V-45V
-
10pcs 7W 9W 12W 15W 7-15W LED Driver Input AC 85-265V Power Supply Built-in Drive Power Supply 260-280mA Lighting for DIY LED Lamps
$28.34Driver ModuleAdd to cartSpecificationsInput voltage:AC 85-265VOutput voltage:DC21-54VOutput current:260-280m(adjustable)Product size:43*18*21mmWorking temperature:Ta:50 TC:75Efficiency:≥87%Power factor:0.6Product application:spotlight PAR light / bulb light / candle light / etc.Package Included10 x 7W 9W 12W 15W 7-15W LED Driver Input AC 85-265V
-
10pcs 7W 9W 12W 15W LED Non Isolated Modulation Light External Driver Power Supply AC90-265V Constant Current Thyristor Dimming Module
$37.79Driver ModuleAdd to cartSpecificationsInput voltage:AC90-265VOutput voltage:DC21-48VOutput current:300mA(adjustable)Product size:68*34*22mmWorking temperature:Ta:50 TC:75Efficiency:≥80%Power factor:0.6Product application:spotlight PAR light / bulb light / candle light / etc.Package Included10 x 7W 9W 12W 15W LED Non Isolated Modulation Light External Driver
-
10pcs 7x2W 12x2W LED Driver Input AC 85-277V to DC 12V-42V Built-in Drive Power Supply Lighting for DIY LED Lamps
$29.69Driver ModuleAdd to cartSpecificationsInput voltage:AC 85-265VOutput voltage:DC12-24VOutput current:300mAProduct size:48*20*13mmWorking temperature:Ta:50 TC:75Efficiency:≥87%Power factor:0.6Product application:spotlight PAR light / bulb light / candle light / etc.Package Included10 x 7x2W 12x2W LED Driver Input AC 85-277V to DC 12V-42V
-
10pcs CA-255 10-42Inch LED TV Constant Current Board Universal Inverte LED TV Backlight Driver Board
$32.40Driver ModuleAdd to cartSpecificationInput Vol:10.8-28VOutput Vol:15-88vsize:8.5×4.5CM1.VCC:power supply and voltage positive, circuit voltage (The voltage is usually 12V or 24V)2.ON / OFF, ON, EN, ON_BL etc:switch foot, foot switch signal (The voltage range is between 2.5V-5V)3. PWM, PDIM, VDAJ, BL-PWM et al:brightness adjustable feet (Dimming have two modes, one is in digital mode -PWM,one is analog dimming -DC4.The PWM …
-
10Pcs DC 5V 4 Phase 5 Wire Stepper Motor With ULN2003 Driver Board
$36.44Driver ModuleAdd to cart10Pcs DC 5V 4 Phase 5 Wire Stepper Motor With ULN2003 Driver BoardDescriptionThis is 28YBJ-48 DC 5V 4 phase 5 wire stepper motor with ULN2003 driver board5-wire phase can drive ordinary uln2003 chip can also be connected as phase 2 may be supporting the development board, direct plug, easy to use stepper motor used in …
10Pcs DC 5V 4 Phase 5 Wire Stepper Motor With ULN2003 Driver BoardRead More
-
10pcs DC Motor Driver Board 2 Way DRV8833 Motor Drive Module DC 3-10V
$17.54Driver ModuleAdd to cartParametersSize:18.5 x 16 mmInput voltage:3-10VSingle H bridge output current:1.5A, can drive 2 dc deceleration motors.Built-in overcurrent protection, short circuit protection, undervoltage latching and overheating protection. Sleep mode with low power consumption.Purpose:drive dc motor and 4-wire stepping motor up to 1.5A.InstructionsULT low level is in sleep mode (need to disconnect J2 short welding spot behind the …
10pcs DC Motor Driver Board 2 Way DRV8833 Motor Drive Module DC 3-10VRead More
-
10pcs DRV8833 2 Channel DC Motor Driver Module Board 1.5A 3V-10V
$26.99Driver ModuleAdd to cartSpecicicationsInput voltage:3 – 10VSize:18.5*16mmSingle H bridge output current:1.5A, can drive 2 DC geared motors.Built-in overcurrent protection, short circuit protection, undervoltage lockout and overtemperature protection. With low power sleep mode.Uses:It can drive DC motors up to 1.5A and 4-wire stepper motors.Instructions for UseULT low level is sleep mode (need to disconnect the J2 short solder joint …
10pcs DRV8833 2 Channel DC Motor Driver Module Board 1.5A 3V-10VRead More
Customers Also Viewed
-
Symcode MJ1400 CCD/2D Wireless/Wired Barcode Scanner 1D Code Scanning Machine for Restaurants Shops Supermarkets
$41.84ScannersAdd to cartFeatures Symcode MJ1400 Red Light Scanner – High-end CCD red light scanning technology, plug-and-play, driver-free installation, state-of-the-art bar code scanning technology, easy to scan all 1D barcodes and screen barcodes. The red flashing mode of the Symcode MJ1400 red light scanner allows users to accurately align the barcode to be scanned. After the users press …
-
Frsky M9-Gimbal M9 High Sensitivity Hall Sensor Gimbal Red Color For Taranis X9D& X9D Plus RC FPV Racing Drone
$55.34Radios & ReceiverAdd to cartFrsky M9-Gimbal M9 High Sensitivity Hall Sensor Gimbal Red Color For Taranis X9D & X9D PlusSpcificationBrand Name:FrskyModel:M9-GimbalItem Name:M9-Gimbal M9 Sensitivity Sensor GimbalSupply Voltage (VCC):DC 3.0 ~ ±0.5VSensitivity:2.50 mV/GLinear Output Voltage Range:0.1 ~ (VCC +0.1) VQuiescent Output (TA = 25°C, B = 0 G):0.5 × VCCNoise (no load):≤40mVpp Features-Hall sensor-4 ball-bearings-Adjustable tension-Can be enable or disable …
-
Gaming Laptop Cooler Five Fan 2 USB Ports 2400RPM Laptop Cooling Pad Notebook Stand for 12” to 17” Notebooks
$55.34Cooling Pads & StandsAdd to cartFeatures100% Brand new and high quality.Lightweight, portable and durable.2 USB ports and 2 wind adjustment switches.Less noise,silent, air flows.8 adjustable angles for choice, giving you a better viewing angle.Switch between large fan, 4 small fans or all 5 fans to give you maximum cooling.Perfect for preventing your laptop from overheating, keeping your laptop being cool.The …
-
Gaoneng GNB 3.8V 3000MAH 1S 5C HV LiPo Battery for Sanwa MT-44 FH4T Remote Controller
$21.59RC Quadcopter PartsAdd to cartGaoneng GNB 3.8V 3000MAH 1S 5C HV LiPo Battery for Sanwa MT-44 FH4T Remote Controller DescriptionItem Name:LiPo BatteryRated Capacity:3000mAh, 11.4WhNominal Voltage:3.8VFlight Time (no wind):About 33minsCharge current:3AWeight:About 50gSize:47 x8.5 x 58mmUsage:For Sanwa MT-44 FH4T Remote Controller Package Included1 x 3.8V 3000mAh Lipo Battery
-
10ml 242 Glue Screw Glue Blue Glue Anaerobic Adhesive for RC Model Frame
$9.44Tools & Bags & StorageAdd to cartTypical Uses1. Applicable to most metal surfaces, can be demolished with ordinary tools.2. For M2 ~ M12 thread locking and sealing.3. Apply to the diameter of not more than 1/4 "of the best when the fasteners, with a certain degree of lubrication in order to achieve accurate clamping load.4. Low strength, removableTechnical ParametersViscosity (mPa.s):1,200 / …
10ml 242 Glue Screw Glue Blue Glue Anaerobic Adhesive for RC Model FrameRead More
